Motorola Symbol LS3578 User's Guide Page 136

  • Download
  • Add to my manuals
  • Print
  • Page
    / 596
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 135
2 - 88 MT2070/MT2090 User Guide
ICMP Ping
The ICMP Ping screen allows testing of a connection at the network layer (part of the IP protocol) between the
device and any other device on the network. Ping tests only stop when Stop Test is selected, the Wireless
Diagnostics application is closed or if the device switches between infrastructure and ad-hoc modes.
To open the ICMP Ping screen, select ICMP Ping in the Wireless Diagnostics screen.
Figure 2-114
ICMP Ping Screen
To perform an ICMP ping:
1. In the IP field, enter an IP address or select an IP address from the drop-down list.
2. From the Size drop-down list, select a size value.
3. Select Start Test. The ICMP Ping test starts. Information of the ping test displays in the appropriate fields. The
following statistics appear on the page:
Signal: The current signal strength, measured in dBm, is provided both as a numerical value and as a
histogram.
Noise: The current noise level, measured in dBm, is provided both as a numerical value and as a
histogram.
SNR: The current signal to noise ratio, measured in dBm, is provided both as a numerical value and as
a histogram.
Total Tx: The total number of pings sent is displayed numerically.
Total Rx: The total number of valid ping responses received is displayed numerically.
Lost: The total number of pings that were lost is displayed numerically.
RT Times: Four round trip times: Last, Average, Minimum and Maximum are displayed in milliseconds.
% Rates: For each of the 12 data rates, the number of times that rate was used to transmit the ping is
displayed as a percentage.
Page view 135
1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 595 596

Comments to this Manuals

No comments