Chapter 2. Initialization and Setup 2-7
MPC564EVB Jumper and Switch Setup
Figure 2-3 on the next page shows the jumper locations for the board.
removed SWITCH1 is for user use
B_RX *insterted CAN: see Section 1.4.2, “CAN PORTs and Options
removed CAN: see Section 1.4.2, “CAN PORTs and Options
C_TX inserted CAN: see Section 1.4.2, “CAN PORTs and Options
*removed CAN: see Section 1.4.2, “CAN PORTs and Options
C_RX inserted CAN: see Section 1.4.2, “CAN PORTs and Options
*removed CAN: see Section 1.4.2, “CAN PORTs and Options
100_IRQ *inserted
Ties the interrupt line from the Ethernet chip to
the interrupt line of the processor
removed Disconnects the interrupt line from the ethernet chip to the
interrupt line of the processor
“ON” * insterted Allows the board to have power.
removed Power to the board should be controlled by an ignition switch
connected to the IGN input on the Power Clamp, TB1.
Table 2-2. Jumper Settings (Continued)
Jumper Setting Function
Frees
cale Semiconductor,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc...
Comments to this Manuals