Motorola RG2200 User's Guide download pdf (Page 71)

No power Power cord is disconnected. Check to make sure that the RG2200 is plugged into a live electrical outlet.

Note: If the outlet is controlled by a wall switch, make sure the switch is on.

VCR will not record VCR is on wrong channel. See “Changing Channels” on page 22.

VCR is programmed incorrectly. Refer to the VCR User’s Manual.

VCR is not connected properly. See “TV/VCR/Audio Connections” on page 59.

VCR is connected with RCA

jacks and is not in correct mode.

Place the VCR on the LINE input. This can be accomplished using the VCR menu or

changing the VCR channel until the display on the VCR indicates LINE.

Safety tab on tape is broken. Use a new tape.

VCR will not play tapes TV on wrong channel for play-

back or not using the correct

input.

Tune TV to correct RF channel.

VCR is not connected properly. See “TV/VCR/Audio Connections” on page 59.

Amber On-line LED You don’t have on-line services. Call your Network Service Provider to initiate service.

Amber Network LED The Gateway is not ready for

use.

Unplug power connection on back of Gateway then reconnect if light stays on more than

10 minutes.

Message on TV screen:

“There is a problem with the

network, Third video not

available.”

Or, you are unable to make

channel changes.

TV program temporarily not

available.

Wait several seconds and try again. If you are still unable to make the channel change,

turn off one of the other TV programs by shutting off the TV with the remote. The

RG2200detects that the TV program is no longer being watched. This should free up

programming for the other TV and should allow you to receive video on the third TV.

Problem Possible Cause Try This

1 ... 70 71 72 ... 88

No comments

Motorola RG2200 User's Guide Page 71