Motorola RG2200 User's Guide download pdf (Page 12)

BOUT RF CHANNELS

Your NSP sets your TV to operate on a specific RF channel. This setting allows you to receive video and audio broadcast

services.

Programming the TV to an RF channel is similar to setting a TV to a specific channel, such as channel 3, in order to view

movies played on your VCR. After the RF channel has been set, it is recommended that you do not change it, as you will no

longer be able to receive programming unless you retune your TV to a new RF channel.

Once your TV is tuned to the specified RF channel, the RG2200 and your remote allow you to surf through the channel line-

up and tune to any program from any TV viewing location. The table below demonstrates how the TV outputs and the RF

channels work together to deliver video and audio programming.

TV OUTPUT Ports

RF Channel

TV1 NETWORK IN/TV OUT

and/or

TV OUT

3, 4, 5, or 6

TV2 7, 8, 9 or 10

TV3 (VDSL only) 11, 12 or 13

1. These RF channels are representative only. Actual RF channels used will vary according to location

and will be determined by your NSP.

1 ... 11 12 13 ... 88

No comments

Motorola RG2200 User's Guide Page 12