Motorola RG2200 User's Guide download pdf (Page 70)

No picture TV or RG2200 may not be acti-

vated.

Refer to “Getting Started” on page 15.

Cable signal may not be reach-

ing your home.

Make sure all cables are connected properly and that your TV is tuned to the correct RF

channel (for example 6,7, or 13) for the TV you are using (TV-1, TV-2, or TV-3). If the

baseband video output on the RG2200 is connected to the VIDEO IN input on the TV,

make sure the TV is set to the correct video input.

VCR may be set incorrectly. Check to see how the VCR is connected to the RG2200. If the baseband video output

on the RG2200 is connected to the VCR, the VCR must be ON and programmed to

VIDEO IN.

Make sure VCR/TV is set to TV.

Make sure the TV is set to the correct TV or video input.

No picture Your RG2200 has recently

received a software download.

Sometimes after a download the

system fails to operate. You may

need to restart your RG2200.

To restart your RG2200, press and hold down the power button on the front panel for 5

seconds.

Picture is distorted Coaxial cable is disconnected or

loose.

Reconnect or tighten the cable.

Blue or black TV screen No video supplied to TV. If VCR is connected using RCA jacks, VCR must be ON to provide picture.

Snowy picture on all TVs VCR is on at this location and TV

is on wrong channel.

Call your NSP to reset your RF channel.

TV is on wrong channel for

Source.

Call your NSP to reset your RF channel.

Only one stereo speaker

has sound

Audio connections are loose. Reconnect audio connections.

Check to make sure that no wires are frayed and no plugs are bent or broken.

Problem Possible Cause Try This

1 ... 69 70 71 ... 88

No comments

Motorola RG2200 User's Guide Page 70