107
Entering GPS Location Service
To enter the GPS sub-menu, press
and select More... > Location:
• Position provides the actual position
information.
• Interface allows you to enable/disable the
GPS location service.
• Setting Accuracy allows you to select high location
accuracy or the energy optimised mode for GPS location
service if the MTP850 is not connected to a charging
device (Digital Car Kit or charger etc.).
Scroll to your selection and press Select to access the next
display.
This estimate of accuracy of the calculated location is only a
very rough estimate and may vary substantially from the
actual accuracy of the approximate location information
reported.
Viewing Your Position
1.From the main menu, select More...
> Location > Position.
2. Scroll to view the entire screen.
This displays the following information about
the last time your location was calculated
(if available):
• The time the location was last calculated
• The latitude expressed in degrees, minutes, and seconds
This feature works in DMO and TMO modes when it is set by the
Service Provider.
• The variation will vary in accordance to the GPS
Configuration set by your Service Provider.
• The availability of the GPS Location menus is dependent on
your terminal configuration, please contact your Service
Provider for further details.
Location
Position
Interface
Accuracy
Select Back
Position
<Time>
<Latitude>
<Longitude>
<Tracked satellites>
Rfrsh Back
Comments to this Manuals