30
AT#UD Unimodem
Diagnostic
Command
The Unimodem Diagnostic Command Specification is provided by Microsoft
to enable modems to exhibit consistent behavior during data session diagnos-
tics. The latest specification revision of this command can be found on the
Microsoft Web site.
Command Syntax:
AT# UD
#UD is an action command. It does not take parameters.
Although this command is intended for use after call termination, codes are
defined so that a modem can respond before the call is placed, and during a
call for live monitoring purposes.
Command Response:
In response to this command, the modem reports information about the
modem. Each information text line is formatted as follows, including one or
more key=value pairs:
DIAG <token key = value [[key = value] [key = value]] …>
Where, token is a unique 32-bit hex number 2A4D3263
key is a hex number, described in column 1 of Table 1.
value is a string defined by column 2 in Table 1.
Note
Unless otherwise noted, all values are hexadecimal numbers.
Table 6- AT#UD Last Call Status Report Format
Key Value Definition
0 2 digits Diagnostic Command Specification revision number
1 See Table 7 Call Setup Result code
2 See Table 8 Multi-media mode
3 See Table 9 DTE-DCE interface mode
4 String V.8 CM octet string, same format as V.25ter Annex
A, in quotes
5 String V.8 JM octet string, same format as V.25ter Annex
A, in quotes
6 - F Reserved for call negotiation reports
10 0-2F Received signal power level, in
–dBm (0-43)
11 0-1F Transmit signal power level, in –dBm (e.g. 0-17)
12 0-64 Estimated noise level, in –dBm (e.g. 10-90)
Comments to this Manuals