Motorola AP6562 Installation Guide download pdf (Page 32)

32 AP6562 Access Point

• Enable NAT on the WAN Interface - Select the checkbox to allow traffic to pass between the access

point's WAN and LAN interfaces.

17. Select Next. The Initial AP Setup Wizard displays the Radio Configuration screen to define support for

the 2.4GHz radio band, 5GHz radio band or to set the radio's functionality as a dedicated sensor.

18. Set the following parameters for the radio:

• Configure as a Data Radio - Select this option to dedicate this radio for WLAN client support in either

the selected 2.4 or 5GHz radio band.

• Radio Frequency Band - Select either the 2.4GHz or 5.0GHz radio band to use with the radio when

selected as a Data Radio. The selected band is used for WLAN client support. Considers selecting

one radio for 2.4GHz and another for 5GHz support when supporting clients in both the 802.11/jointfilesconvert/434149/bg

and 802.11n bands.

• Power Level - Use the spinner control to select a 1 - 23 dBm minimum power level to assign to this

radio in selected 2.4 or 5.0 GHz band. 1 dBm is the default setting.

NOTE The ADSP Sensor Server field displays at the bottom of the screen only

if a radio has been dedicated as a sensor.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 59 60

No comments

Motorola AP6562 Installation Guide Page 32