Motorola SB5101U User's Guide download pdf (Page 32)

SB5101 Cable Modem Overview

MOTOROLA BCS CONFIDENTIAL Page 32 of 34

hosts Displays VxWorks host name table

I Displays a summary of each task and associated TCB (Task Control Block)

ifconfig Display information about all attached network interfaces

ifconfig [interface] Displays information about specific interface

ipcache Displays IP filter cache information

ifcachestat Displays IP filter cache statistics

ipfilter Displays state of IP filters

lkAddr [addr] Displays Engineering symbols whose values are near a specified value

llcfilter Displays LLC filter information

macstat Displays MAC packet counts and statistics

memShow Displays system memory partition blocks and statistics

multicast Displays multicast protocol information

netstat Displays statistics for all protocols

netstat –icmp Displays statistics for ICMP

netstat –ip Displays IP statistics

netstat –inet Displays all active connections for IP sockets

netstat –rn Displays routing tables

netstat –tcp Displays statistics for the TCP protocol

netstat –udp Displays statistics for the UDP protocol

ping <x.x.x.x> Ping an IP address

ping <hostname> Ping an IP host by name (names are only configurable at the Engineering

Diagnostic Level)

quit Exits the login session

reset Reset the Cable Modem

rlogin <hostname> Establishes a rlogin session to hostname (names are only configurable at

the Engineering Diagnostic Level)

routes Displays host and network routing table

setd/jointfilesconvert/299063/bg Sets some debug flags (see below

)

startuplog Displays startup log information

telnet <x.x.x.x> Establishes a telnet session

tftpinfo Displays TFTP information

usdiag Displays upstream diagnostic information, (SID, power level, frequency,

rate)

ver Displays software/hardware versions

10.1.5 Key Debug Flags:

Ignore Auto Update IF 1, Do not auto update the Firmware image upon registration

IF 0, Auto update the Firmware image as designated by TFTP Config file

Canned Registration IF 1, DHCP, TOD, TFTP will be bypassed and canned registration will be

used

Fine Scan on IF 1, Do fine scan

Use Scan Limit IF 1, Perform scan within parameters of the defined scan limits

DHCP Debug On IF 1, DHCP Debug statements are displayed

Confg Debug On IF 1, Config Debug statements are displayed

TOD Debug On IF 1, Time of Day Debug statements are displayed

1 2 ... 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments

Motorola SB5101U User's Guide Page 32

Comments to this Manuals

Related products and manuals for Networking Motorola SB5101U