Motorola MC3000 User's Guide download pdf (Page 28)

MC3000 Integrator Guide1-10

Starting the Mobile Computer

When the mobile computer is powered on for the first time, it initializes. The Symbol Splash screen appears for a short period of time,

followed by the Calibration screen.

Figure 1-5. Symbol Splash Screen

After the calibration procedure is performed the factory settings launch the Series 3000 Demo window. Application specific shells

may provide application specific windows instead of the Series 3000 Demo window. These screens also appear when a cold boot is

performed.

If the mobile computer does not power on, see Resetting the Mobile Computer on page 2-27.

Calibration Screen

Use the Calibration screen to align the touch screen:

1. Remove the stylus from the stylus holder.

2. Carefully press and briefly hold the stylus tip on the center of the Calibration screen target. Repeat the procedure as the

target moves and stops at different locations on the screen. This enters the new calibration settings.

Figure 1-6. Calibration Screen

3. Once all of the new calibration settings are input, the Confirm Calibration Resave screen appears. Tap the screen within 30

seconds to save the new calibration settings or allow the 30 second timer to expire and the new calibration settings are not

saved.

Calibration Screen Confirm Calibration Resave

Screen

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 113 114

No comments

Motorola MC3000 User's Guide Page 28