Canopy T1/E1MultiplexerSeptember2004
T1/E1MultiplexerFPGAVersion3.4
Page14 of 73
1.2.5 FrontPanel
The control port and indicator LEDs are located on the front panel of the unit.
Figure 6: Canopy T1/E1 Multiplexer front panel
Status LEDS
The status indicator LEDS on the front of the Canopy T1/E1 Multiplexer are listed in
Table 3.
Table 3: LED status indicator descriptions
LED
LED indicator descriptions
PWR ON when main power supply is OK; OFF when a malfunction is
detected
RDY ON when self-test is successfully completed; OFF during self-test; and
BLINKING when self-test fails
CANOPY LINK OFF when line is not active; ON when Canopy BH Ethernet line is OK
CANOPY ACT OFF when no activity; BLINKNG when frames are being transmitted or
received on the line
LAN LINK OFF when line is not active; ON when line is OK
Issue3
Comments to this Manuals