19
Programming
Your DSR remote control can be programmed to operate your TV and auxiliary
components. Follow these instructions to program the remote control.
- Turn on the TV or component you wish to program.
- Use the table in this section to find the brand of the desired component.
After the manufacturer’s brand name is one or more four-digit codes.
- Press and hold the TV, VCR or AUX key on the remote control until the
mode keys on the remote flash.
- While the mode keys are flashing, key in the first of the four-digit codes
listed in the table for your brand.
- If it is a usable code the mode key will flash rapidly to indicate that it
has accepted the code. Press the POWER key on the remote control to
make sure the remote control is able to turn your TV or component off
and back on.
- If it is not a usable code use the next four-digit code from the list until
the remote control is programmed correctly.
Components may respond to more than one code. If your component does
not respond to the remote as it should then an alternate code may be more
functional or you can try scanning for an alternate code by using the
following procedure.
If Your Four-Digit Code is not in the Tables (Scan)
If you try to program your remote control using the four-digit codes, and the
remote control does not work correctly, you may be able to find a code that
works by using the “scan” process.
- Turn on the TV.
- Press and hold the TV mode key on the remote control until the mode
keys on the remote begin to flash.
- While pointing the remote control at your TV, press the UP navigation key
to scan upward to the next code. (Use the DOWN key to return to the
previous code.)
- If a transmitted code is the correct one, your
TV will turn off, responding as if its POWER
key were pressed. The mode key will remain
lighted. Press ENTER and the mode key will
blink rapidly indicating acceptance.
- If your TV does not respond, press the UP
navigation key to try the next code. When
your component turns off you will know that
you have found the correct code. Press
ENTER to confirm.
- The VCR and AUX keys may be programmed to operate a variety of
components but you must first program the selected mode with a valid
code or program it using the following starting points: press “1000” if
scanning TV codes; “2000” if scanning VCR codes; “3000” if scanning CD
or DVD codes; “4000” if scanning audio receiver codes; “5219” if
scanning TV/VCR combinations or “6235” if scanning for cable boxes.
The mode key will flash rapidly indicating acceptance. Then press and
hold the AUX or VCR key untill all the mode keys flash. Press the UP
navigation key until your component turns off. Press ENTER and the
mode key will flash to indicate acceptance.
Up
Down
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals