Motorola MT2070 Specifications Page 51

  • Download
  • Add to my manuals
  • Print
  • Page
    / 210
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 50
Accessories 2 - 13
To mount the cradle:
1. Attach the interface and power cables to the appropriate ports (see Figure on page 2-7).
2. Insert the power supply cable ferrite into the support features on the cradle bottom and run the host and power
cables into their respective cable grooves.
3. Position the cradle on the mounting surface and outline the mounting holes with a pencil, or use the mounting
template on page 2-27 to determine the location of the screw holes.
4. Pre-drill holes to accommodate two screws.
5. Attach the cradle key-holes to the screws and ensure the cradle hangs securely on the surface.
6. Place the device in the cradle.
Forklift Single Slot Charge Only Cradle
The mounting bracket is used to install the STB2000-F cradle on a forklift.
Attach the Mounting Bracket
1. Use a Phillips screwdriver to turn the wall mount conversion dial on the back of the cradle to the correct
position for a vertical (wall) mount. The front latches protract to engage the depressions at the base of the
device’s handle.
Figure 2-10
Attaching Forklift Mounting Bracket to Cradle
NOTE Ensure the device does not loosen from the wall during routine usage.
Cable
Access
Hole
Cable Tie
Holes
Cable Tie
Holes
Cable Tie
Holes
Isolator
Isolator
Forklift Mount
Conversion Dial
Mounting Bracket
Page view 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 209 210

Comments to this Manuals

No comments