Motorola L511BT User's Guide download pdf (Page 32)

32 Help

Caller ID does not work

• Check your subscription with your network operator.

• If you subscribe to high-speed internet service (Digital

Subscriber Line - DSL) through your telephone lines, you

must install a DSL filter between the telephone base and

the telephone wall jack. The filter will prevent noise and

caller ID problems caused by DSL interference. Please

contact your DSL service provider for more information

about DSL filters.

A phonebook entry cannot be stored

• The phonebook is full. Delete an entry to free memory.

No display

• Try recharging or replacing the rechargeable battery pack.

• Reset the base. Unplug the unit's electrical, then plug it

back in.

• If the LED is not lit up, then try to unplug the unit's

electrical power, and then plug it back in.

If the handset disconnects from the base during a

phone call

• Check that the power cord is connected properly into the

base.

• Check that the power adapter is connected properly into

the electrical outlet.

• Move the handset closer to the base. It may be out of range.

• Reset the base by unplugging the unit's electrical power.

Wait for around 15 seconds and re-plug the power again.

Allow up to one minute for the handset to synchronize

with the registered base again.

Noise interference on your radio or television

• Your base or charger may be too close. Move it as far

away as possible.

1 ... 31 32 33 ... 43

No comments

Motorola L511BT User's Guide Page 32