Motorola MICOM-2TS Specifications Page 125

  • Download
  • Add to my manuals
  • Print
  • Page
    / 132
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 124
MICOM-2E-ALE Owner’s Manual
86
Problem Troubleshooting
Poor or no transmission
(continued)
If bars are missing on the right side of the RF power bar
graph, it indicates low transmitter power, which can be
caused by a faulty microphone, faulty transmitter,
overheating, or defective antenna system.
In case of a failure during operation, the following messages appear on
the radio’s display:
Table 6. Failure Messages
Message Troubleshooting
NO CLOCK CHECK
That a 30A fuse is installed in the fuse holder located
on the red wire of the power cable.
SYN FAIL Perform a built-in test via the RSS, to obtain more
information.
PW_LATCH Perform a built-in test via the RSS, to obtain more
information.
OVER TMP CHECK
That there is no fan obstruction.
Perform a built-in test via the RSS, to obtain more
information.
CU-LIMIT CHECK
That the radio is programmed to TUNER OFF when
your antenna system is not equipped with an ATU.
If a short circuit occurred in the antenna’s coax.
That the ATU is in working condition.
NOT PROG*
(on the display)
The radio is not programmed and the baud rate is 1200
bit/sec.
Program the radio parameters (from RSS)
*This message will appear if the radio DC power failed during the RSS
programming.
Page view 124

Comments to this Manuals

No comments