Motorola Command One User Manual download pdf (Page 37)

Simulator Commands

Command Summary

MOTOROLA DSP SIMULATOR REFERENCE MANUAL 2-19

EXAMPLES

display on

Enable all registers for display

display on pi:0..20 xi:30..40

Display enable internal p memory address block 0 to 20 and internal x memory address

block 30 to 40.

display off

display on core ssi0

Disable all display, then enable display of the DSP core registers and the SSI0 peripheral

registers.

display w r0..r3 x:0..100

Display conditionally (if they are written) registers r0 through r3 and x memory locations

0 through 100.

Entering the display command with a register or memory list, but without one of the "en-

able" keywords, will cause immediate display of the listed registers and memory locations

without affecting their "enable" status.

The peripheral names can be used in the display list to enable or display all the registers

associated with that peripheral. The valid peripheral names for the selected device can be

obtained by using the Simulator’s "help periph" command. The name all can be used to

enable or display all registers of the selected device.

EXAMPLES

display

Display all currently enabled registers and memory.

display p:0..300

Immediate display of p memory addresses 0 through 300.

display test.asm@7

Immediate display of memory location corresponding to line 7 of source file test.asm.

display xdat

Immediate display of memory location corresponding to symbolic label xdat.

display all

Immediate display of all registers plus the enabled memory locations.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 251 252

No comments

Motorola Command One User Manual Page 37