Motorola MC75 - Worldwide Enterprise Digital Assistant Specifications download pdf (Page 43)

Accessories 2 - 15

Connector Pin-Outs

Mounting the Cradle

1. Select a mounting location for the cradle. It should be flat, and must provide adequate support for the cradle.

2. Prepare the mounting surface to accept four #8-32 studs, using the mounting template below. Drill four holes

with a #6 drill bit.

Table 2-5

Power Input Cable

Pin Signal

1 Chassis ground (Black Wire)

2 Chassis ground (Bare Wire)

3 V+ (Red Wire)

4 V+ (Red Wire)

Table 2-6

Serial Cable

Pin Signal Pin Signal

1 DCD 5 GND

2RxD6DSR

3TxD7RTS

4DTR8CTS

5GND95V_OUT

Connector on Power Cable

Connector on Serial Cable

CAUTION ROAD SAFETY - Do not use the MC75A while driving. Park the vehicle first. Always ensure the MC75A

is fully inserted into the cradle. Do not place it on the seat or where it can break loose in a collision or

sudden stop. Lack of proper insertion may result in property damage or personal injury. Motorola, Inc. is

not responsible for any loss resulting from the use of the products while driving. Remember: Safety

comes first.

CAUTION Only mount the Vehicle Cradle in a vertical position with the release level at the top or in a horizontal position

with the MC75A display facing up. Never mount the vehicle cradle on the side or upside down or on a wall

that can be subject to impact or collision of greater than 40Gs, in accordance with SAE J1455 Section

4.10.3.5

NOTE If using the GPS functionality of the MC75A mobile computer, ensure that the vehicle cradle is positioned so

that the MC75A has a clear unobstructed view of the sky.

1 ... 42 43 44 ... 154

No comments

Motorola MC75 - Worldwide Enterprise Digital Assistant Specifications Page 43