Motorola DCP501 User's Guide download pdf (Page 72)

62 Operation

DCP501 User Guide

* M

I N SE T UP *

X A U D I O S E T U P

D V D S E T U P

C A T V R E C O R D

C A T V C H A N N E L S C A N

E X I T

Test Tone Adjust

The Test Tone option allows you to hear test tones and adjust the level of these tones on

speakers connected to the DCP501 to properly balance the sound system with the listening area.

 For full benefit, Test Tone Adjust should be performed when the DCP501 is in Dolby-Digital

or dts mode.

 You can be in any audio mode except stereo to enter the Test Tone Adjust menu. You can

only adjust the test tone levels for the speakers that are used in the audio mode you have

selected. For example, Dolby 3 Channel Stereo uses left, right, and center speakers. You can

adjust the test tones for these three speakers, but not for either of the surround speakers. In

any of the full surround modes, you can adjust all five test tone levels — left, right, center,

right surround, left surround. You are not allowed to adjust any of the test tones when

stereo mode is selected.

 Set the base volume level of each speaker with this option.

 Perform this operation while sitting at the listening position. The factory setting is

0 dB.

As the tone is played through each speaker, the current setting flashes. Use the DCP501 remote

control or front panel

CURSOR left/right (<

< >

>) to adjust the volume level of each speaker so that

all speaker volumes sound the same.

It is not necessary to press

SETUP or OK to record your settings for each speaker.

To use the Test Tone Adjust feature:

1 Press SETUP to display the DCP501 MAIN SETUP menu on your TV or AUDIO SET on

the DCP501 display.

On-screen Display DCP501 Display

A U D I O S E T

1 ... 71 72 73 ... 141

No comments

Motorola DCP501 User's Guide Page 72