Introduction
Altitude 4600 Series Access Point Installation Guide10
● Slots for wall mounting
● Clips for mounting on a suspended ceiling T-bar
● Lock port for Kensington® style Security Lock
An Altitude 4600 Series Access Point has one RJ-45 connector supporting an 10/100/
1000 Ethernet port and requires 802.3af-compliant power from an external source.
NOTE
When operating in a Gigabit Ethernet environment CAT-5e or CAT-6 cable is required for Gigabit
operation.
An Altitude 4600 Series Access Point comes in dual radio versions both supporting
802.11a/b/g/n.
An Altitude 4600 Series Access Point contains runtime firmware which enables the unit
to boot after either a power up or a watchdog reset. The runtime firmware on the access
point and the firmware downloaded from the controller can be updated via the
Ethernet interface from the controller.
Comments to this Manuals