Motorola AP-650 Series Installation Guide download pdf (Page 12)

12 AP650 Access Point

• Safety wire (recommended) and security cable (optional)

2.6.2 Wall Mount Procedure

1. Orient the case on the wall by its width or length.

2. Using the arrows on one edge of the case as guides, move the edge to the midline of the mounting area and

mark points on the midline for the screws.

3. At each point, drill a hole in the wall, insert an anchor, screw into the anchor the wall mounting screw and

stop when there is 1mm between the screw head and the wall.

NOTE In the event that the original mounting screws are lost, the following

screws can be used instead: (ANSI Standard) #6-18 X 0.875in. Type A or

AB Self-Tapping Screw, or (ANSI Standard Metric) M3.5 X 0.6 X 20mm

Type D Self-Tapping Screw.

NOTE When pre-drilling a hole the recommended hole size is 2.8mm (0.11in.) if

the screws are going directly into the wall and 6mm (0.23in.) if the

provided wall anchors are being used.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

No comments

Motorola AP-650 Series Installation Guide Page 12