Motorola AP-621 Series Installation Guide download pdf (Page 27)

Regulatory Information

5.7 US and Canada

Co-located statement

To comply with FCC RF exposure compliance requirements, the antennas used with this transmitter

must not be co-located, or operating in conjunction, with any other transmitter/antenna except those

already approved in this filling.

Remote and Standalone Antenna Configurations

To comply with FCC RF exposure requirements, antennas that are mounted externally at remote

locations or operating near users at stand-alone desktop of similar configurations must operate with

a minimum separation distance of 20 cm from all persons.

5.8 Power Supply

This device is powered from either a model PWRS-147376-01R 48 volt power supply or a 802.3af

compliant power source which is UL approved and certified by the appropriate agencies.

5.9 Radio Frequency Interference Requirements—FCC

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected

• Consult the dealer or an experienced radio/TV technician for help

Radio Transmitters (Part 15)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Restricted Band 5.60 – 5.65 GHz

AP621 IG.book Page 23 Tuesday, September 20, 2011 3:18 PM

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

No comments

Motorola AP-621 Series Installation Guide Page 27