Motorola AP-51XX User Manual download pdf (Page 254)

100

101

AP-51xx Access Point Product Reference Guide

6-36

4. Click Apply to save any changes to the Advanced Subnet Access screen. Navigating away

from the screen without clicking Apply results in all changes to the screens being lost.

5. Click Undo Changes (if necessary) to undo any changes made. Undo Changes reverts the

settings displayed on the Advanced Subnet Access screen to the last saved configuration.

6. Click Logout to securely exit the Access Point applet. A prompt displays confirming the

logout before the applet is closed.

6.11 Configuring VPN Tunnels

The access point allows up to 25 VPN tunnels to either a VPN endpoint or to another access point.

VPN tunnels allow all traffic on a local subnet to route securely through a IPSEC tunnel to a private

network. A VPN port is a virtual port which handles tunneled traffic.

When connecting to another site using a VPN, the traffic is encrypted so if anyone intercepts the

traffic, they cannot see what it is unless they can break the encryption. The traffic is encrypted from

your computer through the network to the VPN. At that point the traffic is decrypted.

Source IP The Source IP range defines the origin address or address range

for the firewall rule. To configure the Source IP range, click on the

field. A new window displays for entering the IP address and range.

Destination IP The Destination IP range determines the target address or

address range for the firewall rule. To configure the Destination IP

range, click on the field. A new window displays for entering the IP

address and range.

Transport Select a protocol from the drop-down list. For a detailed description

of the protocols available, see Available Protocols on page 6-33.

Src. Ports (Source

Ports)

The source port range determines which ports the firewall rule

applies to on the source IP address. Click on the field to configure

the source port range. A new window displays to enter the starting

and ending port ranges. For rules where only a single port is

necessary, enter the same port in the start and end port fields.

Dst. Ports (Destination

Ports

The destination port range determines which ports the firewall rule

applies to on the destination IP address. Click on the field to

configure the destination port range. A new window displays to

enter the starting and ending ports in the range. For rules where

only a single port is necessary, enter the same port in the start and

end port fields.

1 2 ... 249 250 251 252 253 254 255 256 257 258 259 ... 697 698

Comments to this Manuals

No comments

Motorola AP-51XX User Manual Page 254

Comments to this Manuals

Related products and manuals for WLAN access points Motorola AP-51XX