Motorola Advisor II User Manual download pdf (Page 6)

• Pagers that have been opened by, or had work performed

by, anyone other than a Motorola authorized pager service

center.

• Pagers received with non- conforming or non- Motorola

housings or parts. Flat rate repair fees apply to pagers and

accessories not covered under warranty.

STATE LAW RIGHTS

SOME STATES DO NOT ALLOW THE EXCLUSION OR

LIMITATION OF INCIDENTAL OR CONSEQUENTIAL

DAMAGES, OR LIMITATION ON HOW LONG AN IMPLIED

WARRANTY LASTS, THEREFORE THE ABOVE

LIMITATIONS OR EXCLUSIONS MAY NOT APPLY.

Anyone intending to use a radio in a location

where hazardous concentrations of flammable mate-

rials exist (hazardous atmosphere) is advised to

become familiar with the subject of intrinsic safety

and with the National Electric Code NFPA 70

(National Fire Protection Association) Article 500

(hazardous [classified] locations).

UL Approval labels are attached to the ADVISOR II

Pager to identify the unit as being UL Approved for

specified hazardous atmospheres. This label speci-

fies the hazardous Class/Division/Group which will

appear as follows:

RAD DEV FOR HAZ LOC

DIV2, I, A,B,C,D

RAD DEV FOR HAZ LOC

EXIA: DIV2, I, A,B,C,D

Substitution of Components may impair Intrinsic

safety.

The following is the Approved battery listing

to be used for the UL Approved ADVISOR II.

1.5AA ALK, Duracell MN2400 or Energizer E92

• Do not operate equipment in a hazardous

atmosphere unless it is a type especially

qualified (for example, UL Approved) for such

use. An explosion or fire may result.

• Do not operate a UL Approved Product in a

hazardous atmosphere if it has been physi-

cally damaged (for example, cracked hous-

ing). An explosion or fire may result.

• Do not replace or charge batteries in a haz-

ardous atmosphere. Contact sparking may

occur while installing or removing batteries

and cause an explosion or fire.

W A R N I N G

• Do not replace or change accessories in a

hazardous atmosphere. Contact sparking

may occur while installing or removing acces-

sories and cause an explosion or fire.

• Turn a radio off before removing or installing

a battery or accessory.

• Do not disassemble a UL Approved Product

unit in any way that exposes the internal

electrical circuits of the unit.

• Do not substitute components. This could

void the intrinsic safety rating.

Regulatory Agency Compliance

This device complies with part 15 of the

FCC Rules. Operation is subject to the

following two conditions: (1) This device may

not cause harmful interference, and (2) this

device must accept any interference received,

including interference that may cause unde-

sired operation.

This equipment has been tested and found to

comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reason-

able protection against harmful interference in

a residential installation. This equipment gen-

erates, uses and can radiate radio frequency

energy and, if not installed and used in accor-

dance with the instructions, may cause harm-

ful interference to radio communications.

However, there is no guarantee that interfer-

ence will not occur in a particular installation.

If this equipment does cause harmful interfer-

ence to radio or television reception, which

can be determined by turning the equipment

off and on, the user is encouraged to try to

correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equip-

ment and receiver

• Connect the equipment into an outlet on a

circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/

TV technician for help.

21 22

1 2 3 4 5 6 7

Comments to this Manuals

No comments

Motorola Advisor II User Manual Page 6

Comments to this Manuals

Related products and manuals for Unknown Motorola Advisor II