Motorola V2260 Instruction Manual download pdf (Page 64)

64 4/3/01

CDMA 800/1900

LOGIC TROUBLESHOOTING

Phone is not powered on(1)

Battery Discharged

Measure battery voltage and if the battery voltage is <3.6 V DC, recharge the battery using the

AC charger.

Battery contact opened or misaligned

Supply the B+ power through test port J3002(B+), J3001(GND) by using the test interface cable. If

the phone is powered on, check the battery fail or battery contact defect

B+ Supply defective

Apply the power BATT+ through the battery contact. Check the B+ voltage by measuring 3.6-

4.2V at the pin 48 of U2000 CCAP lite. If the B+ doesn’t come out, check the Q3300

Power Supply defective

Supply the B+ power through test port J3002(B+), J3001(GND) by using the test interface cable.

Depress the PWR button and measure the supplied voltage of each part within 300ms of start of

ON_OFF signal.

Check the Logic_4.75 voltage by measuring 4.75V at the pin 41 of U2000 CCAP lite

Check the Logic_2.75 voltage by measuring 2.75V at the pin 28 of U2000 CCAP lite

Check the Audio_2.75 voltage by measuring 2.75V at the pin 22 of U2000 CCAP lite

Check the Logic_1.8 voltage by measuring 2.75V at the pin 3 of U2000 CCAP lite

If the above supply voltages don’t create by CCAP lite, Replace the U2000 part or check the logic

2.75/ Audio 2.75 power path shortage

Phone is not powered on (2)

Reset Signal

Check the RESETB Signal from CCAP lite U2000 by measuring the voltage of C2044 or pin 30 of

U2000

Depress PWR button, then the RESETB signal shall maintain ‘Low’ for approximately 255msec

after power on and go to ‘High’

If reset signal don’t come out, check the CCAP U2000 part.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 120 121

No comments

Motorola V2260 Instruction Manual Page 64