Motorola PRO2150 Service Manual Page 129

  • Download
  • Add to my manuals
  • Print
  • Page
    / 136
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 128
99R85452E01-O August 30, 2002
Glossary-3
Minimum
Frequency
The lowest frequency setting at which the radio is allowed to operate.
The radio’s frequency range is defined as being between, or equal to,
the Minimum and Maximum frequencies. This information is stored in
the radio’s codeplug.
Model Number The model number identifies the type of radio. This information is stored
in the radio’s codeplug.
Normal Scan For Normal Scan, the radio assigns equal priority to all members in the
Scan List selected for the current channel. When the radio is scanning a
Scan List (Active Scan), all scan list members (including the Home
Channel) will be allocated equal time to be scanned. For example, if the
Home Channel is H1, and the Scan List Members are Nn, then the scan-
ning sequence is: N1, N2, N3, ..., H1, N1, N2, ..., etc.
Offset Frequency If Tx Offset is set to Positive, this frequency will be added to the VFO Rx
Frequency when radio is transmitting. It will be subtracted from the VFO
Rx Frequency if Tx Offset is set to Negative.
Original Codeplug
Version
The first version number of codeplug information that was loaded into
the radio. This is stored in the radio’s codeplug.
PC Board Printed Circuit Board.
Phone Access
Code
The 16 digit Access Code for establishing connection to a telephone line
and subsequent dial tone.
Phone De-access
Code
The 16 digit De-access Code for disconnecting from a phone call.
Phone List A list of phone numbers (up to nine phone numbers) that can be prepro-
grammed into the radios. Each phone number can contain 16 characters
made up by alphabets (A, B, C, D), numbers (0-9), spaces, “#” and “*”.
PL Private-Line® tone squelch: a continuous sub-audible tone that is trans-
mitted along with the carrier.
PLL Phase-Locked Loop: a circuit in which an oscillator is kept in phase with
a reference, usually after passing through a frequency divider.
Pretime Selects the amount of time between PTT button press and the first digit
of ID transmission. This time allows the receiving radio to stabilize
before receiving data.
Priority Scan For Priority Scan, the radio assigns the highest priority to the first mem-
ber in the Scan List selected for the current channel. When the radio is
scanning a Scan List (Active Scan), 50% of the scans are targeted at the
Priority #1 Member channel. For example, if the Priority #1 Member is
P1, and the non-priority Scan List Members are Nn, then the scanning
sequence is: P1, N1, P1, N2, P1, N3, P1, N4, P1, N5, etc.
Term Definition
Page view 128

Comments to this Manuals

No comments