Motorola H01UCC6DU3AN Operations Instructions download pdf (Page 21)

20 Basic Operation

mode” tone until the mode selector

knob and 3-position toggle switch se-

lect a programmed (valid) position.

NOTE: If the channel is busy during conven-

tional operation, the radio’s red LED

will blink in receive operation.

NOTE: The red LED will blink if a low-battery

condition occurs during transmit oper-

ation.

Call Light (Trunking Only)

If this feature is enabled on a group or a universal ID that is re-

ceived, then the green LED will blink. To turn off the call light,

change the group or mode, press the PTT, or press any valid but-

ton.

Monitoring a Conventional Channel

1. To unsquelch the radio while on a conventional channel, press

side button 3. This unmutes the speaker (if open squelch

monitor is programmed using RSS). You may then adjust the

volume with the on/off/volume control.

2. To place the radio in the permanent monitor mode, press and

hold side button 3 for approximately 2.5 seconds (time

programmable using RSS). The radio emits a brief high-pitched

tone as it enters the permanent monitor mode. To return the

radio to its original squelch state, one of the following can be

done: press side button 3 again, press the PTT (Push To Talk)

switch, change modes or channels, or turn the radio off and

on.

Transmitting on a Trunked System

1. Press the PTT switch.

2. If the dit-dit-dit talk permit tones (programmed using RSS) are

heard, continue to push the PTT switch and speak into the

microphone in a normal voice. The red LED indicator will stay

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 48 49

No comments

Motorola H01UCC6DU3AN Operations Instructions Page 21