Motorola GM1280 User's Guide download pdf (Page 32)

30

English

SPECIAL CALLS

However, if the DTE is not present e.g.

disconnected, the SDM is rejected by the radio.

In this case the SDM will not be accepted

(acknowledged) by the radio and will not be

lost.

Summary

If using the radio only, the SDM display should

be set to ON .

If using the radio with external DTE which is

permanently connected in normal use, the

SDM display should be set to ON .

If using the radio with external DTE which may

be disconnected in normal use, then set the

display to OFF prior to disconnecting the

external DTE to avoid SDM loss.

Storing SDMs

Incoming SDMs are stored on receipt in the

Short Data Message Calls List. Up to ten

SDMscanbestoredbytheradio.Thedata

message icon

K is lit whenever SDMs are in

the calls list.

SDMs are not stored when the radio is

switched OFF, except for one SDM only which

can be saved.

Interrogating the SDM Calls List

When an SDM call has been stored by the

radio, the display will show:

With the display showing ‘Data Received’ ,

pressing any of the menu buttons provides a

quick access into the Data Calls List.

The Data Calls List can also be entered

directly by pressing the Data button (if

programmed) when the radio is in the IDLE

STATE or via the menu.

If using the Data button, follow the procedures

from step 4 below.

Data Received

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 63 64

Comments to this Manuals

No comments