Motorola i88s User's Guide download pdf (Page 156)

148

www.motorola.com/iden

To set your phone’s TTY mode from your TTY device, issue one of the

following commands while on an active call:

•“VCO please”—to select VCO mode.

•“HCO please”—to select HCO mode.

•“HCO off please”—to turn off HCO mode.

NOTE: TTY device manufacturer’s proprietary feature such as Turbo-

Code, High-Speed, and Interruption are not supported by your

phone. These features must be turned off or disabled to use

your TTY device with your phone.

Setting TTY Baud Rate

NOTE: This feature may not be offered by your service provider.

By default, your phone’s TTY baud rate is set to 45.45, the baud rate required

for TTY calls within the U.S. To make calls outside the U.S., set your TTY baud

rate to 50.0.

To change the TTY baud rate:

Alert Timeout

Alert timeout controls the amount of time the Call Alert tone sounds. The

display will continue to show the alert information even though the Call Alert

tone has stopped.

You can set your phone’s alert timeout rules from the Initial Setup screen.

Scroll to the Alert Timeout option and then choose the desired interval. (No

Alert Tone, 5 Minutes, 30 Minutes, 1 Hour, or Continuous.

IMPORTANT:

When you are using HCO, the sound coming from

your phone speaker may be uncomfortably loud.

Use caution when putting the phone to your ear.

(For information on setting your phone’s speaker

volume, see “Alert Timeout” on page 148.)

From the Initial Setup screen, press R to scroll to TTY Baud.

Press A under CHANGE.

Press S to scroll to the baud rate for your location.

Press A under SELECT.

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 209 210

No comments

Motorola i88s User's Guide Page 156