Motorola PTP 500 User Manual download pdf (Page 5)

Bench Testing (Optional) - Connect and Power Up

Step 1: Connect the RJ45 at

one end of a cable to the

ODU.

Step 2: Undo the retaining

screw of the PIDU Plus and

hinge back the cover.

Step 4: Put the cover back

and tighten the screw.

Step 3: Plug in the ODU to

PIDU Plus Cable ensuring

that it snaps home.

Step 5: Plug in power lead

using a cable appropriate for

the installation.

Step 6: Connect a second

Ethernet cable (shown in yel-

low) to the “LAN” socket of

the PIDU Plus.

Step 7: 30 seconds after powering, the Ethernet LED

should be observed to flash slowly 10 times. If the Ethernet

LED does not illuminate (Orange), then either the PIDU

Plus or the cable to the ODU may be faulty. Replace cable

and/or PIDU Plus and repeat from Step 1.

NOTE

- If the power LED

does not illuminate, re-

move the power cable

and the ODU connection

from the PIDU Plus. Re-

connect the power lead

and check the power

LED illumination (Green).

If the power LED still

does not light then check

the power source.

Step 8: Ensure PC is set to

correct IP address 169.254.1.x,

where 2 < x < 254. Connect

the LAN cable to the PC

(shown here in yellow).

Step 9: Check that the Ethernet

LED is now ON. Refer to the

Troubleshooting section in this

guide if the LED does not show

any activity when accessing

web pages.

It is advised that the link be configured and tested on a bench before the final installation of the

units on a pole or a mast. The following steps give details of how to connect an ODU to a PC in

order to check the configuration details, change the IP settings or modify the license key. For

the purpose of these tests, normal off-the-shelf Ethernet cables can be used.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments

Motorola PTP 500 User Manual Page 5

Comments to this Manuals

Related products and manuals for Hardware Motorola PTP 500