Motorola MBP28 User's Guide download pdf (Page 12)

12 USING YOUR BABY MONITOR

2.3 Belt clip/stand on parent unit

1. The belt clip/stand attaches to the back of the parent

unit and clips into the locking slots on each side.

NOTE

It will only fit one way, as indicated by UP and the arrows

on the inside of the clip.

2. The unit comes with the accessory fitted in the belt

clip mode.

3. You can convert it into the stand mode, by simply

pulling the back part of the clip out slightly and then

rotating it by half a turn, as shown above.

3. USING YOUR BABY MONITOR

Please read these instructions carefully, and be aware

that this baby monitor is only intended as an aid. It is not

a substitute for responsible, correct parental supervision.

3.1 Power on/off the parent unit

1. When the parent unit is off, press 3 until you hear a

beep and the Power Indicator starts to flash. The

parent unit will search for and link itself to the

registered camera units.

2. When the parent unit is on, press and hold

3 until the

Power Indicator turns off. The parent unit is now

powered off, although the display may take a few

seconds to go off fully.

3.2 Power on/off the camera unit

1. When the camera unit is off, press 0 to power it on.

The Power/Link Indicator will flash for a few

seconds until it links with the parent unit and stays

steadily on.

2. When the camera unit is on, press and hold

0 until

the Power/Link Indicator turns off. The camera unit

is now powered off.

Belt clip

position

Desk position

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

No comments

Motorola MBP28 User's Guide Page 12